![]() ![]() Virtually all newer modems allowing the behavior of the DCD signal to be configured. So long as the DCD signal is high, the computer can assume that any data coming from the modem was sent from the remote side. DCD is deasserted once the local modem is no longer receiving carrier from the remote modem, regardless of which side initiated the disconnect. The signal is asserted at the same time the modem reports its CONNECT message, and stays asserted until the call is disconnected (either intentionally or because of a fault in the line). It is not asserted until the modem either makes an outgoing call, or answers an incoming call, and then connects with a data modem on the other end. This status light is directly coupled with what the modem is sending the DCD line.īy default, when a modem is powered up, the DCD signal is deasserted. Because the words "NO CARRIER" are also a message that could appear in the context of a normal data session (for example, if typed by a person on the remote end), there is no positive way for a computer program to differentiate the words being sent over the connection versus from the modem.Įxternal modems with LED status lights usually have a light labeled "CD" ( carrier detect). It is possible to use a modem without the DCD signal, however the only way for the computer to know that a connection is disconnected is by the modem transmitting the words " NO CARRIER" over the data lines. Aside from intentional disconnects, modems can lose their connection for a variety of reasons unexpectedly - such as the phone line being disconnected. ![]() Much like the Ring Indicator signal, on a PC's serial port, changes to the DCD signal state can generate a hardware interrupt that can be captured by the processor any time the DCD signal changes state, preventing the PC from needing to constantly poll the pin.ĭCD is very important on modems, as it is the computer's primary way to find out that the modem has lost its connection to the remote host. On a data modem, the carrier's loss equates to the connection's termination. The word "carrier" is a reference to the analog carrier signal generated by a modem, which is modulated to carry the data. ![]() ![]() Its purpose varies depending on the device connected, but the most specific meaning is to indicate when a modem is connected to another remote modem via telephone lines. It is present on virtually all PC serial ports - pin 1 of a nine-pin ( DE9) serial port, or pin eight over a 25-pin (DB25) port. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem or other peripheral to a computer in a typical scenario. JSTOR ( March 2023) ( Learn how and when to remove this template message)ĭata Carrier Detect ( DCD) or Carrier Detect ( CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem.Unsourced material may be challenged and removed.įind sources: "Data Carrier Detect" – news Please help improve this article by adding citations to reliable sources. This article needs additional citations for verification. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |